How to Install the Head

1

Using a clean cloth, wipe away oil and dust from the taper and end surfaces of the head and holder.

1

2

Apply a small amount of anti-seize compound to only the screw head part

2

3

Be careful of the application amount. If over-applied, the anti-seize compound while fastened will spread around the taper part and possibly effect the fastening mechanism.

3

Wipe off the anti-seize compound and make adjustments.

4

Be careful to avoid the possibility of cutting hands when fastening with bare hands directly near the blade tip.
Securely fasten the head and holder end surfaces using the enclosed wrench to close off any remaining gap.

4

5

Refer to the table at below regarding angles for recommended torque when necessary.
For stricter usage, refer to the table below for torque wrench fastening.

5

Note 1) Do not handle edges with bare hands.
Note 2) Please use the wrench provided. It is thinner than a standard wrench to prevent damage to the flutes when tightening.

Page Top