STAW

Hone Width

If an insert with honing other than standard is needed, please order using the symbols below.

tec_drilling_operation_staw_01_en-us.png

Notes On Use

Insert Installation

INSERT INSTALLATION

1.Before inserting the insert into the holder, ensure that there are no foreign objects or dirt in the holder slot or slit. Clean using compressed air if necessary.

figure 1

2. Use the wrench provided to loosen the inner screw to open the tip of the holder, then place the insert into the holder slot as shown in figure 1.
*Ensure that the wrench is firmly in contact with the base of the inner screw head when tightening.

figure 2

3. After the insert has been set in the holder slot, tighten the inner screw while pushing the insert lightly into the pocket as shown in figure 2 to securely clamp and locate the insert.
*Ensure that the wrench is firmly in contact with the base of the inner screw head when tightening.

Tighten clamp screws referring to the table for torque.

Tighten the clamp screw according to the torque


4. Check there is no gap between the bottom of the insert and holder slot.

Check there is no gap

Poor or incorrect clamping of inserts can cause poor drilling performance and/or drill breakage.
Therefore ensure that the alignment marks on both the body and insert are aligned when setting.
When machining, use safety guards and eye protection.

Page Top